Zeiss KF 2 ICS Especificaciones descargar pdf (Pagina 53)

Start-Up

Axiostar plus Attaching epi-fluorescence illuminator Carl Zeiss

B 40-815 e 12/01 2-31

We recommend the following procedure if you

need to install filters without direction markings

(arrow):

Filters with reflective, dielectric layers should be

installed so that the reflective layer

– Points out for an excitation filter (in relation

to the reflector module)

and

– Points in for an emission filter (Fig. 2-28).

2.11.7 Changing color splitter in P&C

reflector module

Extreme care is required when attaching the

filter and color splitter to avoid damage to the

optical elements and to keep them clean.

We recommend ordering completely equipped

P&C reflector modules since changing the color

splitter has higher requirements.

To replace a color splitter:

• Remove P&C reflector module from

reflector revolver.

• Loosen both slotted screws

(2-29/1) with a screwdriver.

• Hold together both halves of the reflector

module, turn against the installation

position and set aside.

1 Locking filter (emission filter)

2 Reflective layer on emission filter

3 Color splitter

4 Reflective layer on the color splitter

5 Excitation filter

6 Reflective layer on the excitation filter

7 Illumination/Imaging beam path

Fig. 2-28 Inserting filter and color splitter

1 Slotted screws

2 Module half: emission

3 Module half: excitation

Fig. 2-29 Changing color splitter

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 99 100

Sin comentarios

Zeiss KF 2 ICS Especificaciones Pagina 53