Zeiss Axioplan 2 imaging and Axiophot 2 Guía de usuario descargar pdf (Pagina 28)

There seems to be a way to avoid the problem: it occurs only when many image windows

are open at the same time in cascade mode (windows partially one on the other). When

windows are maximized (e.g. by double clicking the upper bar), the software seems to

behave properly.

15.3 Microscope

15.3.1 General

Microscope beeps when I try to focus.

Check the focusing limit setting and override it if necessary (Chapter 7).

The microscope can‟t be controlled with the software.

Check that the microscope is on (chapter 2.1). If the microscope was turned on after starting

the software you should exit and restart the software.

15.3.2 Fluorescence light microscopy

Fluorescence lamp doesn‟t light up.

The bulb might be burnt, ask MIU to install a new one.

Fluorescence lamp is on but no light comes to the specimen.

Check that both shutters are open (chapter 3.1).

Check that the holder of the UV-protector in microscope 2 (orange plastic plate close to the

objectives) has been properly installed, otherwise it might block the light path.

Fluorescence light image is very noisy.

Check white balance settings (chapter 10.5).

15.3.3 Transmitted light microscopy

Light source for transmitted light doesn‟t light up.

Check if both switches for light source are on (chapter 2.3).

Check the voltage setting (chapter 2.3).

Try to turn the microscope off and then back on (chapter 2.1).

Transmitted light image is too red / too blue.

Check white balance settings (chapter 10.5).

15.3.4 Camera

It‟s not possible to acquire an image.

Check that the camera is on (chapter 2.3). If the camera was turned on after starting the

software you should exit and restart the software.

1 2 ... 23 24 25 26 27 28

Sin comentarios

Zeiss Axioplan 2 imaging and Axiophot 2 Guía de usuario Pagina 28