Zeiss Axiolab A Especificaciones descargar pdf (Pagina 63)

START-UP

Axio Lab.A1 Mounting optional components Carl Zeiss

04/2013 430037-7144-001 63

3.2.3 Mounting and centering the

overview fixture

x Lift the condenser carrier together with its drive

knob upwards as far as it will go.

x Remove the polarizer or filter holder from the

condenser carrier as applicable.

x Hold the overview fixture or filter holder

(Fig. 3-27/2) parallel to the underside of the

condenser carrier (Fig. 3-27/1) and screw the

holding pin (Fig. 3-27/4) of overview fixture

with the angled adjusting lever (Fig. 3-27/6) into

the front left threaded hole below the

condenser carrier as far as it will go.

x Screw the locking pin (Fig. 3-27/8) with

adjusting lever (Fig. 3-27/7) as far as it will go

into the rear threaded hole of the condenser

carrier.

x Swivel the overview fixture into the beam path.

Ensure that it is securely locked into place.

x Completely open the aperture and luminous-

field diaphragm.

x Use the SW 1.5 hexagonal socket wrench to set

the two adjusting screws (Fig. 3-27/3 and 5)

until the field of view is optimally illuminated.

The overview fixture should only be mounted on condenser 0.9/1.25.

Fig. 3-27 Mounting the overview fixture

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 117 118

Sin comentarios

Zeiss Axiolab A Especificaciones Pagina 63