Zeiss Axiolab A Especificaciones descargar pdf (Pagina 7)

INTRODUCTION

Axio Lab.A1 Notes on instrument safety Carl Zeiss

04/2013 430037-7144-001 7

1 INTRODUCTION

1.1 Notes on instrument safety

Axio Lab.A1 microscopes have been designed, produced and tested in compliance with DIN EN 61010-1

(IEC 61010-1) and IEC 61010-2-101 safety requirements for electrical measuring, control and laboratory

instruments.

These instruments meet the requirements of EC Directive IVDD 98/79/EC (In Vitro Diagnostic); they carry

the mark.

This operating manual includes information and warnings which must be observed by the user.

The following warning and instruction symbols are used in this manual:

CAUTION

This symbol indicates a potential hazard to the user.

CAUTION

Hot surface!

CAUTION

UV radiation emitted!

CAUTION

Disconnect the instrument from the power supply before opening!

CAUTION

This symbol indicates a potential hazard to the instrument or system.

NOTE

This symbol denotes a warning to which special attention must be paid.

Axio Lab.A1 microscopes, including original accessories, may only be used for the microscopy methods

described in this manual.

The following instructions must be carefully observed:

The manufacturer is unable to assume any liability for any o

ther use, including individual

modules and individual components. This also applies to all service and repair work not

performed by authorized service personnel. Furthermore, all warranty rights will be forfeited.

The socket into which the power cable

is plugged must be earthed. The grounding effect must

not be made ineffective by an extension cable that does not have a protective ground wire.

1 2 3 4 5 6 7 8 9 10 11 12 ... 117 118

Sin comentarios

Zeiss Axiolab A Especificaciones Pagina 7