Zeiss N HBO 103 Especificaciones descargar pdf (Pagina 51)

Axioskop 40 START-UP

Axioskop 40 FL Attachments and conversions Carl Zeiss

B 40-810 e 12/01 2-21

2.2.3 Attaching filter mount

• If necessary, remove the polarizer or overview

adapter from the condenser carrier.

• Hold filter mount (2-25/5) parallel to the

bottom of the condenser carrier (2-25/3) and

screw holding pin (2-25/4) of filter mount

(2-25/5) into the front threaded hole to the left

below the condenser carrier (2-25/3) as far as it

will go using the SW 2 angled Allen key

(2-25/6).

• Use adjusting lever (2-25/1) to screw stop bolt

(2-25/2) into the rear threaded hole of the

condenser carrier as far as it will go.

• Different filters (32 mm) can be inserted in the

filter mount, e.g. the white-balance filter. If

only one filter is to be used, this can be placed

directly on the luminous field diaphragm.

2.2.4 Attaching polarizer D

• Where necessary, remove the filter mount or

overview adapter from the condenser carrier.

• Hold polarizer (2-26/6) parallel to the bottom of

the condenser carrier (2-26/3) and screw in

holding pin (2-26/4) of the polarizer (2-26/6)

with angled adjusting lever (2-26/5) into the

front threaded hole to the left below the

condenser carrier (2-26/3) as far as it will go.

• Screw in stop bolt (2-26/2) with adjusting lever

(2-26/1) as far as it will go into the rear

threaded hole of the condenser carrier (2-26/3).

Fig. 2-25 Attaching the filter mount

Fig. 2-26 Attaching polarizer D

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 145 146

Sin comentarios

Zeiss N HBO 103 Especificaciones Pagina 51